Skip to content

Getting Started

An important first step in the assembly of your PRO CNC machine is to read through this Getting Started section. It will explain how the assembly instructions are laid out and helpful tips before beginning assembly.

Bookmarks
This set of instructions is based on the components you chose during the Machine Selection step. You may use your browser's Bookmark feature to save a link to this guide, or any section within, for future reference.

PDF Instructions
You may generate and download your assembly instructions as a PDF file at the Downloads & Links main menu item.

Instructions Layout

  1. The machine assembly instructions are broken down into different sections (base assembly, riser assembly, etc.) that correspond with how the machine components are packaged. Complete each section in order.
  2. Each section begins with an image of the fully assembled component. If needed, refer to this as a reference while completing individual assembly steps.
  3. Each section will identify the parts and tools needed for those assembly steps, as well as which box contains those parts. Identification of fasteners is easier if they are kept in their respective fastener bags.
  4. Assembling the larger components, such as the base and optional leg kit, is made easier with two people. Though not required, this can make the process more efficient.
  5. Throughout the instructions, you will see notes like the ones shown below.

Assembly Note

Assembly notes are used to call attention to certain parts of the assembly step. Pay close attention to these as they provide important information for a successful machine build.

Section Note

Section notes contain information that is specific to an entire section of instructions.

Alternate Cable Track Location

These notes provide additional instructions if you want the table cable track and electronics enclosures located on the machine's left side.

Roll-in T-Nut Assembly

Throughout the assembly of your machine, you will use Roll-in T-Nuts. Review these assembly steps for proper use of this component.

Tnut_001
  • Assembly steps will depict Roll-in T-Nut installation as shown above.
Tnut_002
  • To install in the appropriate extrusion slot, position the T-Nut as indicated.
Tnut_003
  • Insert the T-Nut into the extrusion slot and rotate 90°.
Tnut_004
  • When properly installed, the indicated face of the T-Nut will be parallel with the face of the extrusion.

Assembly Note

A small allen wrench can be inserted into the hole of the T-Nut and subsequently used to rotate it the full 90°.

Unpacking Cardboard Tubes

The profile linear rails and gear rack for your machine are packaged in cardboard tubes. Take care when opening to prevent damage to these components.

steelTube_002
  • Use a utility knife (or similar tool) to cut the cardboard 20mm (3/4") from either end of the tube.